User manual

49
Part 2
Go to Advanced Setup – Interface Group screen and select the Enable Virtual
Ports checkbox. The screen will display as follows.
NOTE: Only the Bridge PVC is shown on the Port Mapping configuration. It is in
the format of “nas_x_y_z” where x=port, y=vpi, and z=vci.
To continue, click the Add button at the bottom of the screen shown above. On the
next screen, select the bridge connection and one Ethernet virtual port (ENET 1-4)
and enter a Group Name, such as “MSP1”, as shown below. Click Save/Apply.
If successfully configured, the Port Mapping screen will display as follows.