User manual

48
6.1.2 MSP
Multi-Service over PVC (MSP) supports multiple protocols over a single connection.
As with the VLAN Mux function, PPPoE, Bridge and MER protocols can coexist, while
IPoA and PPPoA are not supported. This function supports remote management by
bridge protocol in addition to multimedia applications over a single PVC.
Configuring MSP is a two-part process:
Part 1 - Create multiple PVCs (One Bridge + multiple PPPoE / One MER)
Part 2 - Use Port Mapping to connect LAN / WAN interfaces
The following example shows how to configure a Bridge / PPPoE MSP connection.
The same process can be used for Bridge / MER MSP connections.
NOTE: If QoS is configured on the first MSP connection, it will be configured by
default for all subsequent connections.
If a MSP connection is removed every other MSP connection should be
removed to avoid port mapping configuration problems.
Part 1 – Create Multiple PVCs
On the Advanced Setup – WAN screen, create one PPPoE connection and one Bridge
connection on the MSP supporting PVC. The screen will display as follows.