User manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Web User Interface
- Chapter 4 Quick Setup
- Chapter 5 Device Information
- Chapter 6 Advanced Setup
- Chapter 7 Wireless
- Chapter 8 Diagnostics
- Chapter 9 Management
46
Firewall Shows enable or disable Firewall
QoS Shows enable or disable QoS
State Shows enable or disable WAN connection
Remove Select or deselect the connection for removal
Edit Click Edit to change connection settings
6.1.1 VLAN Mux
VLAN Mux is a form of VLAN tagging that allows multiple protocols over a single
connection.
This option is found on the Advanced WAN Setup screen. This is the first screen
you will see when adding or editing a connection. VLAN Mux can be enabled by
selecting the VLAN Mux – Enable Multiple Protocols Over a Single PVC check
box, outlined in red below. Input a value between 0 and 4095 for 802.Q VLAN ID.
Then, input a value between 0 and 7 for 802.1P Priority.
After proceeding to STEP 3 in section 4.2 Manual Quick Setup, the screen will
appear as follows. Notice that PPPoA and IPoA are not available.