User manual

45
Chapter 6 Advanced Setup
This chapter explains the following screens:
6.1 WAN 6.8 DNS
6.2 LAN 6.9 DSL
6.3 NAT 6.10 Print Server
6.4 Security 6.11 Interface Group
6.5 Parental Control 6.12 IP Sec
6.6 Quality of Service (QoS) 6.13 Certificate
6.7 Routing
6.1 WAN
This screen allows for the advanced configuration of WAN interfaces.
• To Add a WAN connection, click the Add button. To edit an existing connection,
click the Edit button next to the connection. To complete the Add or Edit, on the
opening screen, select VLAN Mux (see section 6.1.1) and then proceed to STEP
2 in section 4.2 Manual Quick Setup.
• To remove a connection select its radio button under the Remove column in the
table and click the Remove button under the table.
• Save/Reboot activates the new configuration.
VPI/VCI VPI (0-255) / VCI (32-65535)
VLAN Mux Shows 802.1Q VLAN ID
Con. ID ID for WAN connection
Category ATM service category, e.g. UBR, CBR…
Service Name of the WAN connection
Interface Name of the interface for WAN
Protocol Shows bridge or router mode
IGMP Shows enable or disable IGMP proxy
NAT Shows enable or disable NAT