User manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Web User Interface
- Chapter 4 Quick Setup
- Chapter 5 Device Information
- Chapter 6 Advanced Setup
- Chapter 7 Wireless
- Chapter 8 Diagnostics
- Chapter 9 Management
32
4.2.4 Bridging
Step 4: Select the Bridging radio button and click Next. The following screen
appears. S elect Enable Bridge Service and click Next.
Step 5: On this screen, you can change the LAN IP address of the router.
NOTE: In bridge mode, the router is not associated with a WAN IP address. This
means that it can only be managed from a PC on the LAN. For remote
management, you must select a routing type (PPPoE/A, MER, or IPoA).