User manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Web User Interface
- Chapter 4 Quick Setup
- Chapter 5 Device Information
- Chapter 6 Advanced Setup
- Chapter 7 Wireless
- Chapter 8 Diagnostics
- Chapter 9 Management
18
4.2 Manual Quick Setup
STEP 1: Click Quick Setup and un-tick the DSL Auto-connect checkbox to
enable manual configuration of the connection type.
STEP 2: Enter the Virtual Path Identifier (VPI) and Virtual Channel Identifier (VCI)
values. Select Enable Quality Of Service if required and click Next.
STEP 3: Choose an Encapsulation mode.
Choosing different connection types provides different encapsulation modes.
• PPPoA- VC/MUX, LLC/ENCAPSULATION
• PPPoE- LLC/SNAP BRIDGING, VC/MUX
• MER- LLC/SNAP-BRIDGING, VC/MUX
• IPoA- LLC/SNAP-ROUTING, VC MUX
• Bridging- LLC/SNAP-BRIDGING, VC/MUX
Untick this checkbox to enable manual
setup and display the following screen.