User`s manual

The user must configure the IP Address and the Subnet Mask. To use the DHCP

service on the LAN, select the Enable DHCP server checkbox, and enter the Start

IP addresses, the End IP address and DHCP lease time. This configures the router to

automatically assign IP addresses, default gateway address and DNS server

addresses to each of your PCs.

Select Enable DHCP Server Relay (if required), and enter the DHCP Server IP

Address.

Note that the router’s default IP address is 192.168.1.1 and the default private

address range provided by ISP server in the router is 192.168.1.2 through

192.168.1.254.

7. The WAN Setup-Summary screen presents the entire configuration summary.

Click Save/Reboot if the settings are correct. Click Back if you wish to modify the

settings.

The following screen will be displayed.