User`s manual

3. After entering your settings, select Next. The following screen appears. The

Device Setup page allows the user to configure the LAN interface IP address, subnet

mask and DHCP server. If the user would like this ADSL router to assign dynamic IP

addresses, DNS server and default gateway to other LAN devices, select the radio

box Enable DHCP server on the LAN to enter the starting IP address and end IP

address and DHCP lease time. This configures the router to automatically assign IP

addresses, default gateway address and DNS server addresses to each of your PCs.

Note 1: Enable DHCP Server Relay will not display if NAT is enabled in the

previous step.

Note 2: The router’s default IP address is 192.168.1.1 and the default private

address range provided by the ISP server in the router is 192.168.1.2 through

192.168.1.254.

Select Enable DHCP Server Relay (if required), and enter the DHCP Server IP

Address. This allows the router to relay the DHCP packets to the remote DHCP server.

The remote DHCP server will provide the IP address.

To configure a secondary IP address for the LAN port, click the box as shown below.