User`s manual

After all connections have been made, turn the power-switch to the on position. After

powering on, the router performs a self-test. Wait for a few seconds until the test is

finished, then the router will be ready to operate.

Reset Button

Restore the default parameters of the router by holding down the device’s Reset button

until the LED’s start blinking simultaneously (about 5 seconds). After the device has

rebooted successfully, and if the connection is established, the LAN LED, ADSL LED or

USB LED will display in green, depending on the connection type.

Caution 1: If the router fails to power up, or it malfunctions, first verify that the

power supply is connected correctly. Then power it on again. If the

problem persists, contact our technical support engineers.

Caution 2: Before servicing or disassembling this equipment always disconnect

all power cords and telephone lines from the wall outlet.

2.2 USB Device Driver Auto-run Installation

Before you connect your router’s USB cable to your PC, you must load the ADSL USB

drivers. The auto-run USB driver installation supports Win ME, Win 98, Win 2000,

Win XP (32 bit) and Vista (32 bit). For those using Windows XP 64 bit, the driver

needs to be installed manually (please see section 2.3 below for details), and the

driver is also enclosed on the CD-ROM.

To connect the router to a PC using the USB interface, you need to use a standard

USB cable and install the USB interface software. Follow the steps below:

STEP 1: Insert the Installation disk and the following screen will be displayed. Click

the Next button to continue.