User manual

30
DHCP Server Relay: Enable with checkbox ; and enter DHCP Server IP address.
This allows the Router to relay the DHCP packets to the
remote DHCP server. The remote DHCP server will provide
the IP address. This option is hidden if NAT is enabled or
when the router is configured with only one Bridge PVC.
2
ND
LAN INTERFACE
To configure a secondary IP address, tick the checkbox ; outlined (in RED) below.
IP Address: Enter the secondary IP address for the LAN port.
Subnet Mask: Enter the secondary subnet mask for the LAN port.
5.4 NAT
To display this option, NAT must be enabled in at least one PVC shown on the
Advanced Setup - WAN screen. (NAT is not an available option in Bridge mode)
5.4.1 Virtual Servers
Virtual Servers allow you to direct incoming traffic from the WAN side (identified by
Protocol and External port) to the Internal server with private IP addresses on the
LAN side. The Internal port is required only if the external port needs to be
converted to a different port number used by the server on the LAN side.
A maximum of 32 entries can be configured.
To add a Virtual Server, click Add. The following will be displayed.