User manual

126
H2.3 BRIDGING
STEP 1: Select the Bridging radio button and click Next.
STEP 2: The WAN Setup - Summary screen shows a preview of the WAN service
you have configured. Check these settings and click Apply/Save if they
are correct, or click Back to return to the previous screen.
After clicking Apply/Save, the new service should appear on the main screen.
To activate it you must reboot. Go to Management Æ Reboot and click Reboot.
NOTES: If this bridge connection is your only WAN service, your PC IP settings will
need to be assigned statically (see section 3.2), since the on-board DHCP
server is not active in bridge mode.
Similarly, the CT-5364A cannot be accessed from the WAN, for remote
management or technical support, since no WAN IP address is available.