User manual

117
STEP 3: Choose a layer 2 interface from the drop-down box and click Next.
The WAN Service Configuration screen will display as shown below.
NOTE: The WAN services shown here are those supported by the layer 2
interface you selected in the previous step. If you wish to change your
selection click the Back button and select a different layer 2 interface.
STEP 4: For VLAN Mux Connections only, you must enter Priority & VLAN ID tags.
STEP 5: You will now follow the instructions specific to the WAN service type you
wish to establish. This list should help you locate the correct procedure:
(1) For PPP over ETHERNET (PPPoE), go to page 118.
(2) For IP over ETHERNET (IPoE), go to page 122.
(3) For BRIDGING, go to page 126.
(4) For PPP over ATM (PPPoA), go to page 127.
(5) For IP over ATM (IPoA), go to page 131.
The subsections that follow continue the WAN service setup procedure.