User manual

Assign Differentiated Services

Code Point (DSCP) Mark

The selected Code Point gives the

corresponding priority to the packets that

satisfies the rules set below.

Source MAC Address A packet belongs to SET-1, if a binary-AND of

its source MAC address with the Source MAC

Mask is equal to the binary-AND of the Source

MAC Mask and this field.

Source MAC Mask This is the mask used to decide how many

bits are checked in Source MAC Address.

Destination MAC Address A packet belongs to SET-1 then the result

that the Destination MAC Address of its

header binary-AND to the Destination MAC

Mask must equal to the result that this field

binary-AND to the Destination MAC Mask.

Destination MAC Mask This is the mask used to decide how many

bits are checked in Destination MAC Address.

6.6 Routing

This option allows for Default Gateway, Static Route, and RIP configuration.

NOTE: In bridge mode, the RIP screen is hidden while the Default Gateway

and Static Route configuration screens are shown but ineffective.

6.6.1 Default Gateway

If the Enable Automatic Assigned Default Gateway checkbox ; is selected, this

router will accept the first received default gateway assignment from one of the

PPPoA, PPPoE or MER/DHCP enabled PVC(s). If the checkbox ; is not selected,

enter the static default gateway AND/OR a WAN interface. Click Save/Apply.

NOTE: After enabling the Automatic Assigned Default Gateway, the device must

be rebooted to activate the assigned default gateway.