User manual

5
Chapter 2 Installation
2.1 Hardware Setup
Follow the instructions below to complete the hardware setup.
The diagram below shows the back panel of the device.
Power ON
Press the power button to the OFF position (OUT). Connect the power adapter to
the power port. Attach the power adapter to a wall outlet or other AC source.
Press the power button to the ON position (IN). The Power LED indicator should
light up (GREEN). The device first performs a POST (Power On Self Test). If the
POST fails, the LED will turn RED. Wait a few moments for the test to finish. If the
light is a steady GREEN, the device is ready for setup.
Caution 1: If the device fails to power up, or it malfunctions, first verify that the
power cords are connected securely. Then power it on again. If the
problem persists, contact technical support.
Caution 2: Before servicing or disassembling this equipment, disconnect all power
cords and telephone lines from their outlets.
Reset Button
Restore the default parameters of the device by pressing the Reset button for 5 to
10 seconds. After the device has rebooted successfully, the front panel should
display as expected (see section 2.4 LED Indicators for details).
NOTE: If pressed down for more than 12 seconds, the CT-5361T will go into a
firmware update state (CFE boot mode). The firmware can then be
updated using an Internet browser pointed to the default IP address.