User manual

58
Mark IP Type Of Service Normal Service, Minimize Cost, Maximize
Reliability, Maximize Throughput, Minimize Delay
Mark 802.1p if 802.1q is
enabled on WAN
Select between 0-7. The higher the digit shows
the higher the priority.
SET-1
Physical LAN Port Select between ENET(1-4) and USB
Protocol TC P, T C P / U D P, U D P, o r I C M P.
Source IP Address Enter the source IP address.
Source Subnet Mask Enter the subnet mask for the source IP address.
UDP/TCP Source Port (port or
port:port)
Enter source port number or port range.
Destination IP address Enter destination IP address.
Destination Subnet Mask Enter destination subnet mask.
UDP/TCP Destination port (port
or port:port)
Enter destination port number or port range.
SET-2
802.1p Priority Select between 0-7. The lower the digit shows
the higher the priority
If the Enable Differentiated Service Configuration checkbox ; is selected,
some additional fields will display, as shown below.
The additional Items are explained here.