User manual

33
4.2.4 Bridging
STEP 4: To enable bridge service, tick the checkbox ; and enter a service name.
STEP 5: Click Next to display the following screen.
Enter the IP address and subnet mask for the LAN interface. These settings are
used to manage the CT-5361T. In bridge mode, there is no WAN IP address and
therefore no remote access to the router for technical support or other purposes.
STEP 6: Click Next to proceed to the Wireless Setup screen. To enable wireless,
tick the checkbox ; and click Next. If you wish to do so, you may also
change the SSID (Service Set Identifier) at this point.