User manual

84
After the Restore Default Configuration button is selected, the following screen
appears. Close the device Configuration window and wait for 2 minutes before
reopening the browser. If necessary, reconfigure your PC IP address to match your
new configuration (see section 3.2 IP Configuration for details).
After a successful reboot, the browser will return to the Device Info screen. If the
browser does not refresh to the default screen, close and restart the browser.
NOTE: The Restore Default function has the same effect as the reset button. The
device board hardware and the boot loader support the reset to default
button. If the reset button is continuously pushed for more than 5
seconds (and not more than 12 seconds), the boot loader will erase the
configuration settings saved on flash memory.
9.2 System Log
The System Log option under Management allows for the viewing of system
events and configuration of related options. The default setting for the System Log
is enabled. Follow the steps below to enable and view the System Log.
STEP 1: Click Configure System Log to begin.
Step 2: Select the system log options (see table below) and click Save/Apply.