User manual

7
Chapter 2 Installation
2.1 Hardware Installation
Follow the instructions below to complete the hardware installation.
For your reference, the figure below shows the back panel of the CT-5365.
Connection to ADSL - Connect the ADSL line to the ADSL port with RJ11 cable.
Connection to LAN
Use RJ45 straight through or crossover MDI/X cable to connect up to four devices.
Reset Button
Restore the default settings of the device by holding down the Reset button until the
front panel LED indicators blink simultaneously (~ 5 seconds). This action may be
required if the router fails to respond normally or if the router configuration changes.
The router has rebooted successfully when the LED indicators display as expected.
WPS button
Press this button to begin searching for WPS clients. It works if the client also
enables WPS push button mode. When WPS mode is available (the WPS LED will be
ON), pressing the button for 5 seconds or more will disable Wireless function.
Power ON
Press the power button to the OFF position (OUT). Connect the power adapter to
the power port. Attach the power adapter to a wall outlet or other AC source. Press
the power button to the ON position (IN). If the Power LED indicator lights up
(GREEN) then the device is ready for setup.
Caution 1: If the device fails to power up, or it malfunctions, first verify that
the power cords are connected securely. Then power it on again.
If the problem persists, contact technical support.
Caution 2: Before servicing or disassembling this equipment, always disconnect
all power cords and telephone lines from their outlets.
Power
button
Reset
button
WPS
button