User manual

61
To create a group from the list, first enter the group name and then select from the
available interfaces on the list.
Automatically Add Clients With the Following DHCP Vendor IDs:
Add support to automatically map LAN interfaces to PVC's using DHCP vendor ID
(option 60). The local DHCP server will decline and send the requests to a remote
DHCP server by mapping the appropriate LAN interface. This will be turned on when
PortMapping is enabled.
There are four PVCs (0/33, 0/36, 0/37, and 0/38). 0/33 is for PPPoE and the others
are for IP setup-box (video). The LAN interfaces are eth0.1, eth0.2, eth0.3, eth0.4
and Wireless. Port mapping configuration is:
1. Default: eth0.1, eth0.2, eth0.3, eth0.4, Wireless, and Wireless_Guest.
2. Video: nas_0_36, nas_0_37, and nas_0_38. The DHCP vendor ID is "Video".
The CPE's DHCP server is now running on "Default". In addition, ISP's DHCP server
is running on PVC 0/36. It is for setup-box use only.
On the LAN side, the PC can get an IP address from CPE's DHCP server and access
the Internet via PPPoE (0/33).
If the setup-box was connected with interface "eth0.1" and sent a DHCP request
with vendor id "Video", CPE's DHCP server will forward this request to ISP's DHCP
server; and CPE will change the port-mapping configuration automatically. The
port-mapping configuration will become:
1. Default: eth0.2, eth0.3, eth0.4, Wireless, and Wireless_Guest.
2. Video: nas_0_36, nas_0_37, nas_0_38, and eth0.1.