User manual

52
Mark IP Type Of Service Select either: Normal Service, Minimize
Cost, Maximize Reliability, Maximize
Throughput, Minimize Delay
Mark 802.1p if 802.1q is enabled on
WAN
Select between 0-7. The lower the digit
shows the higher the priority.
SET-1
Physical LAN Port Select between eth0, Wireless and
Wireless_Guest.
Protocol TCP, TCP/UDP, UDP, or ICMP.
Source IP Address Enter the source IP address.
Source Subnet Mask Enter the subnet mask for the source IP
address.
Source Port (port or port:port) Enter source port number or port range.
Destination IP address Enter destination IP address.
Destination Subnet Mask Enter destination subnet mask.
Destination Port (port or port:port) Enter destination port number or port range.
SET-2
802.1p Priority Select between 0-7. The lower the digit
shows the higher the priority
If the Enable Differentiated Service Configuration checkbox ; is selected,
some additional fields will display, as shown below.