User manual

6.2 LAN

This screen allows the user to configure the LAN Interface on the device.

NOTE: NAT is enabled above so UPnP is shown (see underlined notes below

Consult the field descriptions below for more details.

IP Address: Enter the IP address for the LAN port.

Subnet Mask: Enter the subnet mask for the LAN port.

Enable UPnP: Tick the box to enable Universal Plug and Play.

This option is hidden when NAT disabled or if no PVC exists

Enable IGMP Snooping: Enable by ticking the checkbox.

Standard Mode

: In standard mode, multicast traffic will flood all

bridge ports when no client is subscribed to a multicast group.

Blocking Mode

: In blocking mode, the multicast data traffic will

be blocked and not flood all bridge ports when no client is

subscribed to a multicast group.

DHCP Server: To enable DHCP, select Enable DHCP server and enter starting

and ending IP addresses and the leased time. This setting

configures the router to automatically assign IP, default gateway

and DNS server addresses to every PC on your LAN.

DHCP Server Relay: Enable with checkbox and enter DHCP Server IP address.

This allows the Router to relay the DHCP packets to the

remote DHCP server. The remote DHCP server will provide

the IP address. This option is hidden if NAT is enabled