User manual

39
Chapter 6 Advanced Setup
This chapter explains the following advanced setup screens:
6.1 WAN 6.6 Routing
6.2 LAN 6.7 DNS
6.3 NAT 6.8 DSL
6.4 Security 6.9 Port Mapping
6.5 Quality of Service 6.10 Certificate
6.1 WAN
Follow these steps to configure the WAN interfaces.
STEP 1: To Add a new WAN connection, click the Add button. To edit an existing
connection, click the Edit button next to the connection. To complete
either an Add or Edit, go to STEP 2 in section 4.2 Manual Quick Setup.
Heading Description
VPI/VCI ATM VPI (0-255) / VCI (32-65535)
Con. ID WAN connection ID number
Category ATM service category
Service Name of the WAN connection
Interface Name of the interface for WAN
Protocol Shows the connection type
IGMP Shows enable or disable IGMP proxy
QoS Shows if IP QoS is enabled or disabled
VlanId VLAN ID is used for VLAN Tagging (IEEE 802.1Q)
State Shows the connection state of the WAN connection
Remove To remove a connection select the radio button in this column and
click the Remove button under the table.
Edit Used to edit connections