User manual

Enable IGMP Multicast (Proxy): Tick the checkbox to enable IGMP multicast.

IGMP (Internet Group Membership Protocol) is a protocol used by IP hosts to report

their multicast group memberships to any immediately neighboring multicast

routers.

Enable WAN Service: Tick the checkbox to enable WAN service.

Service Name: This is the WAN Service label.

Step 6: Click Next to display the following screen.

The Device Setup screen allows the user to configure the LAN interface IP address,

subnet mask, and DHCP server. To enable DHCP, select Enable DHCP server and

enter starting and ending IP addresses and the leased time.

This setting configures the router to automatically assign IP, default gateway and

DNS server addresses to every PC on your LAN. Please be aware that the private

address range (e.g. 192.168.1.2 ~ 192.168.1.254) should not include the router’s

LAN interface IP address (e.g. 192.168.1.1 by default). Also, the Ethernet interface

and wireless LAN share the same subnet since they are bridged within the router.

Select Enable DHCP Server Relay (not available if NAT enabled), and enter the

DHCP Server IP Address. This allows the Router to relay the DHCP packets to the

remote DHCP server. The remote DHCP server will provide the IP address.