User manual

4.2.3 IP Over ATM

Step 4: Select IP over ATM (IPoA) and click Next. The following screen appears.

NOTE: Since DHCP is not supported over IPoA, users must manually enter the IP

address or WAN interface for the default gateway and the DNS server

addresses (primary and secondary), as provided by their ISP.

Step 5: Click Next. The following screen appears.

Enable NAT

If the LAN is configured with a private IP address, the user should select this

checkbox. The NAT submenu will display after the next reboot. The user can then

configure NAT-related features. If a private IP address is not used on the LAN side,

this checkbox should not be selected so as to free up system resources.

Enable Firewall

If the firewall checkbox is selected, the Security submenu will display after the next

reboot. The user can then configure firewall features. If the firewall is not used, this

checkbox should not be selected so as to free up system resources.