User manual

The Device Setup screen allows the user to configure the LAN interface IP address,

subnet mask, and DHCP server. To enable DHCP, select Enable DHCP server and

enter starting and ending IP addresses and the leased time.

This setting configures the router to automatically assign IP, default gateway and

DNS server addresses to every PC on your LAN. Please be aware that the private

address range (e.g. 192.168.1.2 ~ 192.168.1.254) should not include the router’s

LAN interface IP address (e.g. 192.168.1.1 by default). Also, the Ethernet interface

and wireless LAN share the same subnet since they are bridged within the router.

Select Enable DHCP Server Relay (not available if NAT enabled), and enter the

DHCP Server IP Address. This allows the Router to relay the DHCP packets to the

remote DHCP server. The remote DHCP server will provide the IP address.

To configure a second IP address for the LAN port, click the box shown below.

STEP 7: Enable (or disable) Wireless and input an SSID. Click Next to proceed.