User`s manual

5.13.4.1. Enable/Disable L2 filtering

If you wish to Enable/Disable Bridge L2 filtering, click Enable or Disable and click

the Set button. This setting applies to the list of layer 2 bridge filtering entries.

5.13.4.2. Add a Bridge L2 filter entry

To add an L2 filtering entry, complete the following steps:

STEP 1: Complete the parameters on the screen:

 Priority: Enter a priority value from 0-19. The lower the priority value, the

higher the entry’s priority. These priority values will dictate the order of

precedence in which packets will be processed.

 Destination MAC: This is the destination MAC address of the packet. Enter the

address, or click the Set Multicast button to set the address to the Multicast

MAC address. If the address is set to 00:00:00:00 or left blank, then this field

will be ignored when verifying whether the packet should be passed through or

dropped.

 Source MAC: This is the source MAC address of the packet. If the address is

set to 00:00:00:00 or left blank, then this field will be ignored when verifying

whether the packet should be passed through or dropped.

 Ethernet Type: Enter the Ethernet Type in hexadecimal format. For example,

enter 0800 for IP address, or enter 0806 for ARP.

 Interface: Select the interface for the packet, from the Interface dropdown list.

The available interface options are eth0, wlan0 and atm0.

 Action: Select either Allow or Deny, to allow or deny the packet to pass through.

STEP 2: Click the Add button at the bottom of the L2 Filter page to apply the

settings.

5.13.4.3. Delete an L2 filter entry

To delete an L2 filtering entry select an entry and then click the Delete button at the

bottom of the L2 Filters page.