User`s manual

60
Fill out the following fields and click Apply to submit the settings.
Public Address This is the public address where Internet users access.
Enter a specific IP address, or enter 0.0.0.0 to allow any
IP Address (if you wish to use the NAT interface address
enter 0.0.0.0).
Note:
if you use 0.0.0.0 as the public address and the NAT
interface is not active (interface is not linked-up or not
configured)
NONE on public address field. It means there is not
any active NAT interface to do the PortMaping.
NONE will be
displayed in public address field, as shown below:
Public Port From
/Public Port To
Enter the public port range. These ports will be mapped
or redirected to the local ports of the virtual on the LAN.
Internet users access the virtual server via the public
port.
Local Address Enter the IP address of the virtual server on the LAN.
Local Port
From/Local Port To
Enter the Local port range of the virtual server on the
LAN.
Protocol Specify the protocol: TCP or UDP.