User manual

25
STEP 5: Click Next to display the following screen.
Enter the IP address and subnet mask for the LAN interface. These settings are
used to manage the CT-5072S. In bridge mode, there is no WAN IP address and
therefore no remote access to the router for technical support or other purposes.
STEP 6: Click Next to display the configuration summary. Click Save/Reboot if
the settings are correct. Click Back if you wish to modify the settings.
After clicking Save/Reboot, the router will save the configuration to the flash
memory and reboot. The Web UI will not respond until the system is brought up
again. After the system is up, the Web UI will refresh to the Device Info screen
automatically. The CT-5072S is ready for operation when the front panel LED
indicators display as described in section 2.2 LED Indicators.