User`s manual

Chapter 2 Installation
2.1 Hardware Installation
In the rear panel, there is a reset button. It is used to load the factory default
settings. Hold down the button until the LED’s start blinking simultaneously
(about 5 seconds). After the device has booted successfully, the factory default
settings are retrieved.
10
Power Switch
Reset button
Follow the instructions below to complete the hardware connections.
Connection to LINE port
If you wish to connect both the router and a telephone, connect the LINE port to a
POTS splitter with a RJ11 connection cable.
Connection to LAN port
To connect to a hub or PC, use a RJ45 cable. You can connect the router to one LAN
device. The ports are auto-sensing MDI/X and either straight-through cable or
crossover cable can be used.
Connection to Power