User manual

50
Mark 802.1p if 802.1q is
enabled on WAN
Select between 0-7. The higher the digit shows
the higher the priority.
SET-1
Protocol TCP, TCP/UDP, UDP, or ICMP.
Source IP Address Enter the source IP address.
Source Subnet Mask Enter the subnet mask for the source IP address.
UDP/TCP Source Port (port or
port:port)
Enter source port number or port range.
Destination IP address Enter destination IP address.
Destination Subnet Mask Enter destination subnet mask.
UDP/TCP Destination port (port
or port:port)
Enter destination port number or port range.
SET-2
802.1p Priority Select between 0-7. The lower the digit shows
the higher the priority
If the Enable Differentiated Service Configuration checkbox ; is selected,
some additional fields will display, as shown below.
The additional Items are explained here.
Assign Differentiated Services
Code Point (DSCP) Mark
The selected Code Point gives the
corresponding priority to the packets that
satisfies the rules set below.