User manual

38
Chapter 6 Advanced Setup
This chapter explains the following screens:
6.1 WAN 6.6 Routing
6.2 LAN 6.7 DNS
6.3 NAT 6.8 DSL
6.4 Security 6.9 Certificate
6.5 Quality of Service
6.1 WAN
This screen allows for the configuration of WAN interfaces. To Add a new WAN
connection, click Add. To edit an existing connection, click the Edit button next to
the connection. To complete the Add or Edit go to STEP 2 in section 4.2 Manual
Quick Setup. To remove a connection select its radio button under the Remove
column of the table and click the Remove button under the table.
Heading Description
VPI/VCI ATM VPI (0-255) / VCI (32-65535)
Con. ID WAN connection ID number
Category ATM service category
Service Name of the WAN connection
Interface Name of the interface for WAN
Protocol Shows the connection type
Igmp Shows Internet Group Management Protocol (IGMP) status
Nat Shows Network Address Translation (NAT) status
QoS Shows Quality of Service (QoS) status
VlanId VLAN ID is used for VLAN Tagging (IEEE 802.1Q)
State Shows the connection state of the WAN connection
Remove Used to select connections for removal
Edit Used to edit connections