User manual

This screen allows for the configuration of the CT-5071T LAN interface IP address,

subnet mask and DHCP server. To auto-assign IP addresses, DNS server and

default gateway to other LAN devices, select the Enable DHCP server radio box.

You must also enter the start and end IP address and DHCP leased time.

Select Enable DHCP Server Relay (if required), and enter the DHCP Server IP

Address. This allows the router to relay the DHCP packets to the remote DHCP

server. The remote DHCP server will provide the IP address.

NOTE: Enable DHCP Server Relay will not display if NAT is enabled.

To configure a secondary IP address for the LAN port, click the checkbox ; shown.

STEP 7: Click Next to display the configuration summary. Click Save/Reboot if

the settings are correct. Click Back if you wish to modify the settings.

After clicking Save/Reboot, the router will save the configuration to the flash

memory and reboot. The Web UI will not respond until the system is brought up

again. After the system is up, the Web UI will refresh to the Device Info screen

automatically. The CT-5071T is ready for operation when the front panel LED

indicators display as described in section 2.3 LED Indicators.