User manual

Using this method, security settings are configured with a personal identification

number (PIN). The PIN can be found on the device itself or within the software.

The PIN may be generated randomly in the latter case. To obtain a PIN number for

your client, check the device documentation for specific instructions.

The WPS PIN configuration is described in the procedure below. It is assumed that

the Wireless function is Enabled and that the router is configured as the Wireless

Access Point (AP) of your wireless LAN. In addition, the wireless client must also be

configured correctly and turned on, with WPS function enabled.

NOTE: Unlike the push-button method, the pin method has no set time limit.

This means that the router will continue searching until it finds a client.

Step 6: Select the PIN radio button in the WSC Setup section of the Wireless

Security screen, as shown in A or B below, and then click the appropriate

button based on the WSC AP mode selected in step 2.

A - For Configured mode, enter the client PIN in the box provided and

then click the Add Enrollee button (see below).

B - For Unconfigured mode, click the Config AP button.

Step 7: Activate the PIN function on the wireless client. For Configured mode,

the client must be configured as an Enrollee. For Unconfigured mode,

the client must be configured as the Registrar. This is different from the

External Registrar function provided in Windows Vista.

The figure below provides an example of a WPS client PIN function in-progress.

Now go to Step 8 (part IV. Check Connection) to check the WPS connection.