User manual

72
Step 2: Set the WPS AP Mode. Configured is used when the AR-5382u will assign
security settings to clients. Unconfigured is used when an external
client assigns security settings to the AR-5382u.
NOTES: Your client may or may not have the ability to provide security settings to
the AR-5382u. If it does not, then you must set the WPS AP mode to
Configured. Consult the device documentation to check its capabilities.
In addition, using Windows Vista, you can add an external registrar using
the StartAddER button ( Appendix D - WPS External Registrar has
detailed instructions).
II. NETWORK AUTHENTICATION
Step 3: Select Open, WPA-PSK, WPA2-PSK, or Mixed WPA2/WPA-PSK network
authentication mode from the Manual Setup AP section of the Wireless
Security screen. The example below shows WPA2-PSK mode.
Step 4: For the Pre-Shared Key (PSK) modes, enter a WPA Pre-Shared Key. You
will see the following dialog box if the Key is too short or too long.