User manual

Field Description

Ether Type Set the Ethernet type (e.g. IP, ARP, IPv6).

Source MAC Address A packet belongs to SET-1, if a binary-AND of its source

MAC address with the Source MAC Mask is equal to the

binary-AND of the Source MAC Mask and this field.

Source MAC Mask This is the mask used to decide how many bits are checked

in Source MAC Address.

Destination MAC

Address

A packet belongs to SET-1 then the result that the

Destination MAC Address of its header binary-AND to the

Destination MAC Mask must equal to the result that this

field binary-AND to the Destination MAC Mask.

Destination MAC Mask This is the mask used to decide how many bits are checked

in Destination MAC Address.

Classification Results

Assign Classification

Queue

The queue configurations are presented in this format:

“Interfacename&Prece P&Queue Q” where P and Q are the

Precedence and Queue Key values for the corresponding

Interface as listed on the Queue Config screen.

Mark Differentiated

Service Code Point

The selected Code Point gives the corresponding priority to

packets that satisfy the rule.

Mark 802.1p Priority

Select between 0-7. Lower values have higher priority.

Ta g V LA N I D Enter a 802.1Q VLAN ID tag [2-4094]