User manual

123
F2.3 Bridging
NOTE: This connection type is not available on the Ethernet WAN interface.
STEP 1: Select the Bridging radio button and click Next. You can also enable IPv6
by ticking the checkbox  at the bottom of this screen.
STEP 2: The WAN Setup - Summary screen shows a preview of the WAN service
you have configured. Check these settings and click Apply/Save if they
are correct, or click Back to return to the previous screen.
After clicking Apply/Save, the new service should appear on the main screen.
To activate it you must reboot. Go to Management  Reboot and click Reboot.
NOTE: If this bridge connection is your only WAN service, the AR-5382u will be
inaccessible for remote management or technical support from the WAN.