User manual

110
On the next screen, check that the ATM interface is added to the list. For example,
an ATM interface on PVC 0/35 in Default Mode with an EoA Link type is shown below.
To add a WAN connection, go to section G2 ~ WAN Connections.
This table is provided here for ease of reference.
Heading Description
Interface WAN interface name.
VPI ATM VPI (0-255)
VCI ATM VCI (32-65535)
DSL Latency
{Path0}  portID = 0
{Path1}  port ID = 1
{Path0&1}  port ID = 4
Category ATM service category
Link Type Choose EoA (for PPPoE, IPoE, and Bridge), PPPoA, or IPoA.
Connection Mode Default Mode – Single service over one interface.
Vlan Mux Mode – Multiple Vlan services over one interface.
MSC Mode – Multiple Services over one interface.
IP QoS Quality of Service (QoS) status.
Scheduler Alg The algorithm used to schedule the data in the queues. There
are two algorithms to choose, strict priority and weighted fair
queueing.
Queue Weight The weight of the specified queue. This value decides how
much data can be sent in every cycle for this queue.
Group Precedence The precedence of the specified group. This value decides the
order of sending data for this queue in this group for every
cycle regardless of FIFO. The default queue precedence (strict
priority) is 8(lowest).
Remove Select interfaces to remove.
NOTE: To add WAN connections to one interface type, you must delete existing
connections from the other interface type using the remove button.