User guide

Chapter 3 - VMS Configuration 3-25
VMS Network Configuration
If the initial InBand setting failed (did not show the correct Home State in
the Subnet view), check to ensure these settings are correct.
This tab can be used to change Home State settings for a remote. Enter the
desired settings and revert the uplink carrier. Remember to reset the Home
State parameters in the modem and save them after doing this.
Figure 3-28 Subnet Properties, InBand tab
6. The Policy tab (figure 3-29) allows the operator to modify policy settings for
this remote site that are inherited from the global Policy tab (see the section
“InBand Manager” on page 5-18).
Minimum, Maximum and Excess Bit Rates can be either left at 0 bps, which
will cause the InBand to use the global settings, or set to the desired values
for local control.