User guide

VMS Network Configuration
3-18 VMS User Guide
If multiple remotes are involved in a SHOD connection, the VMS uses the
lowest remote gain value for compensation control.
4. Select the Visibility tab to configure the Antenna Visibility range, as shown
in figure 3-17.
Caution: Unless specific limitations are required for the antenna range, the
recommended settings are 500 GHz center frequency and 1 THz
bandwidth (defaults). Refer to Appendix B, "Antenna Visibility", for
more information on this feature.
Figure 3-17 Antenna Visibility, Default Settings
5. Click on the OK button to complete the antenna creation.
The new antenna will appear under the satellite in the ViperView window.
6. Repeat the previous steps to create additional antennas.
Create Antenna Devices
The following steps cover the creation of the antenna up converters and down
converters, and binding the modem modulators and demodulators to the
converters.
1. Right-click on an Antenna icon and select Create Up Converter. The dialog
box shown below(figure 3-18) will open.
It is important to ensure that the Up Converter frequencies are correct, as
this is a very common error which breaks the switching engine.