User guide

Chapter 3 - VMS Configuration 3-11
VMS Network Configuration
Figure 3-9 Vipersat Manager, Registration tab
16. Select the Monitor & Control radio button if this network is to be man-
aged by this VMS, otherwise select Monitor Only.
17. Click the OK button to save these settings for the Vipersat Manager Proper-
ties.
VMS Network Build Procedure
Subnet Manager Configuration
Most of the work here will be done by VMS. The operator needs to verify that
each subnet has all of the expected elements populated in the subnet.
Once all the management addresses are correct and communicating, the Subnet
Manager will start to populate with VMS controlled modem IP subnets. If some
or all units are not populating, the managing VMS address (configured in each
VMS controlled modem during the automatic registration) may not correct.
After the subnet list population is complete, the VMS stores all listed subnets,
any reference to nodes within each subnet, and in-band configurations in the
VMS database.
Note: All VMS controlled modems that have IP communications with the VMS
will have their subnet address added to the VMS database.
NOTE