User guide

Chapter 3 - VMS Configuration 3-7
VMS Network Configuration
Configure Auto Activate
1. Right-click on the Server icon and select Properties from the drop-down
menu.
2. In the General tab, check the box for Auto Activate as shown in figure 3-6.
This will automatically activate the server processes the next time the VOS
service is started.
Figure 3-6 Server Properties, Auto Activate
Configure Addresses and Assign ID
1. Right click on Vipersat Manager from the ViperView tree view list and
select Properties. The Vipersat Manager window will open.
2. Select the General tab shown in figure 3-7, and make sure that the
Management Multicast Address of the VMS matches the Receive Multi-
cast Address for each modem in the network that is controlled by this VMS.
This address is used to propagate managing multi-command messages from
the VMS to all receiving IP network modems.