User guide

Entry Channel Mode (ECM)
G-6 VMS User Guide
3. Click the Modify... button to display the Remote Entry dialog shown in
figure G-5. You can use the up and down arrows next to the button to change
the selected remote.
Figure G-5 Remote bandwidth entry, CDM-570/570L
4. To force a switch from ECM SCPC mode to STDMA mode, set the current
value in the SCPC Data Rate dialog box to 0 (zero) as shown in figure G-5
then click the OK button.
Note: This switch must be performed manually.
5. In VMS, right click on the remote from the drop-down menu shown in
figure G-6 then click on the Revert Uplink Carrier command. This causes
VMS to send the revert command to the target VMS controlled modem
causing it to revert to its STDMA home state.
Figure G-6 Revert uplink carrier command, VMS controlled modem
6. This completes resetting the remote VMS controlled modem to operate in the
STDMA mode.
NOTE