User guide

Load switching
F-8 VMS User Guide
Figure F-3 Switching menu for a remote, CDM-570/570L
Figure F-4 Load switching menu for remote, SLM-5650A
• Auto Switching - Same as Hub
• SCPC Step Up Threshold - Same as STDMA Slot Capacity at hub.
• SCPC Step Down Threshold - Similar to STDMA Slot Capacity at hub
except Step Down is used to trigger a switch if the average load falls
below this value
• SCPC Step Delay - Same as STDMA Switch Delay at hub
• SCPC Stepup Excess - Same as Percent Allocation at hub. Note that the
value applies to both Step Up and Step Down switches and if computed
against the average traffic load at the time the switch is initiated.