User guide

N:M Hub Modem Redundancy
C-36 VMS User Guide
Figure C-35 Ethernet Interface page, CDM-570/570L
6. On the Vipersat Configuration page shown in figure C-36, set the Unit Role
to Hub Expansion.
7. This completes setting the unit to the Passive Configuration mode if it is a
CDM-564L. It is possible the unit was being used to supply voltage to a
LNB, which is described below.
Figure C-36 Vipersat configuration page, CDM-570/570L
8. On the Satellite Modem > Configuration > Configuration > Tx Configura-
tion page shown in figure C-37, disable the unit’s transmit capability by
changing the Tx Carrier to [Off].