User guide

Appendix C - Redundancy C-35
N:M Hub Modem Redundancy
2. On the Administration > Feature Configuration page shown in
figure C-33, enter the unit’s features and unlock codes.
Figure C-33 Feature configuration page, CDM-570/570L
3. Disable STDMA
4. On the Administration page shown in figure C-34, set the Working Mode
to Router - Vipersat.
Figure C-34 Administration page, CDM-570/570L
5. Using the Internet Interface page shown in figure C-35, set the unit’s IP
address to the IP address of the backup unit which replaced it. If you do not
use this IP address, make certain that the IP address is on the hub subnet and
is not being used by any other active or backup unit.