User guide

Chapter 6 - Out-of-Band Units 6-13
Switching SNMP Out of Band Modems
remote modem right clicking on the hub modem will allow the operator to
free up the bandwidth resources by selecting Reset. Unless you are certain
the remote modem is no longer transmitting do not free up its resources as it
will then act as a foreign carrier in the network.
Figure 6-17
7. If you attempt to do an OBCM switch and it fails it is most probably a mis-
configuration of the out of band modems (check the antennas to insure they
are enabled), insufficient bandwidth or other errors in the RF chain.
Figure 6-18