User guide

Chapter 6 - Out-of-Band Units 6-11
Switching SNMP Out of Band Modems
Configuring the OBCM
If the steps above for configuring the RF chain have been completed the follow-
ing procedure can be used to configure the OBCM. This also assumes that each
of the OOB units have been correctly declared and associated with there proper
antenna components.
1. Open the Out of Band Circuit Manager by left clicking on the icon in the tree
view as illustrated in figure 6-13.
Figure 6-13 Out of Band Circuit Manager
2. Select “Create Channel” to open up the dialog below.
Figure 6-14 Channel Configuration
3. The following parameters must be set:
• A channel ID. This must be unique within the system
• A channel name