User guide

Chapter 6 - Out-of-Band Units 6-7
Configuring the RF Chain
Configuring the RF Chain
The following procedure shows how to configure the SNMP Modem’s RF chain
and enable it for switching.
1. Expand the modem icon to show the Modulator and Demodulator. Select the
appropriate antenna and expand the up and down converters as shown in
figure 6-8 below:
Figure 6-8 Configuring the RF Chain
2. Drag and drop the modulator on to the up converter and the demodulator to
the down converter.
3. Right click on the antenna, click the properties page and select the Out of
Band tab as shown in figure 6-9 below: