User guide

VMS Service Managers
5-32 VMS User Guide
Caution: Read the Reset Uplink warning carefully, as performing this operation
on a unknown transmitting unit may cause carrier interference on
operating network. It is safe to reset resources for a remote if it is
known that the remote is not transmitting, powered down or faulty.
Delete
Click the Delete command will delete the subnet from the network,
Properties
The Subnet Properties page tabs are described below.
General Tab
The General tab allows the operator to view or change the name of the subnet.
Subnets declared are listed in the External Subnets list.
Note: External subnets apply when an application or ToS switch originates
past a router at the remote.
Figure 5-46 Properties general tab
• Insert - Clicking the Insert button brings up the New Subnet dialog
shown in figure 5-47. Enter the IP address and subnet mask for the new
subnet in the Address and Mask dialog boxes.
NOTE