User guide

VMS Network Configuration
3-48 VMS User Guide
Figure 3-57 Dynamic Routing Entry, CDM-570/570L
9. Push the new route to the modem with a Force Registration. The modem
will generate a RIPv2 update to the router identified as its default gateway.
This can be verified by right-clicking on the modem, selecting Configure,
then opening the Routing tab as shown in the figure.
10. Repeat this route procedure for each TDM outbound modem.
If Quality of Service rules apply, configure them now. Typically, QOS rules in
the TDM will be configured for Min/Max priority. This gives each remote a
CIR (min rule) in the TDM outbound and a burstable rate (max rule). Since the
number of rules per modem is limited to 32, these rules should be moved to the